Datalogic-scanning C-BOX 200 Bedienungsanleitung PDF herunterladen (Seite 16)

C-BOX 200

2.4.1 System Wiring

The connection and wiring procedure for C-BOX 200 is described as follows:

1) Open the C-BOX 200 as described in paragraph 2.2.

2) Verify that the C-BOX 200 power switch is off (see Figure 8).

3) Unscrew the compression connectors and pass all the system cables

through them into the C-BOX 200 housing.

4) To connect the power and input/output signals:

• Prepare the individual wires of the system cables by stripping the

insulation back approximately 1 cm.

• Using a device such as a screwdriver, push down on the lever directly

next to the clamp (see Figure 7).

• Insert the wire into the clamp and release the lever.

The wire will now be held in the spring clamp.

Figure 7 - System Cable Connections

The wiring used can be solid or stranded but must meet the following specifications.

All positions: 24 - 16 AWG 0.2 - 1.5 mm²

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 27 28

Keine Kommentare

Datalogic-scanning C-BOX 200 Bedienungsanleitung Seite 16